Farmall & IHC Tractors Discussion Board |
Gen to Alternator conversion wiring question (3 wi
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Nawlens Gator on February 26, 2007 at 08:14:17 from (52.128.30.23):
Where does the 18ga wire with diode from the alternator go? I understand the load side of the inition switch, but I have 2 different key switches (2 tractors, both IH 140's, 12V neg Grnd). One has a 2 position key switch that sends votage to the coil when on, and a push button switch that turns the starter over with or without the key switch. The other has a 3 position key switch that sends voltage to the coil when in position 2, and voltage to the magnetic relay (which engages the starter)when in position 3 (spring loaded, temporary on). I'm guessing the 18 ga wire with diode goes to the coil side of the key switch in each case. Am I right? Any help appreciated.
Replies:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|