Farmall & IHC Tractors Discussion Board |
Re: Re: '47 Super-A rear lift bar variations 3-point adapters
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by J.R. on January 03, 2002 at 07:28:57 from (158.73.247.4):
In Reply to: Re: '47 Super-A rear lift bar variations 3-point adapters posted by Haas on January 03, 2002 at 07:06:25:
Haas - I don't have a handy picture but will get one. I'm still hoping someone knows the rear rockshaft I refer to. There are holes in the end of the arms off the rear rockshaft I refer to (as well as chain hanger clips), but probably 6-8 inches higher than the rockshaft you had. The clevis swivels at the ends of the arms of the rear lift shown in the manual seem necessary for the adapter kit, but maybe a chain extension (if lateral motion is a minor problem) would allow use of the hitch adapter. Also, I suspect that the upper adapter part (3rd point bolted to drawbar) may not fit the rockshaft because the spacing between the arms extending off the rockshaft may be closer together on mine. JR
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|