Farmall & IHC Tractors Discussion Board |
M Fender mounting hole depth?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Zim on December 16, 2001 at 15:11:40 from (65.28.240.2):
Today I decided to start cleaning the dirt out of the mounting holes for rear fenders. I planned to clean them out, chase the threads with a tap, then buy some brackets and fenders. I was getting along well by soaking the dirt with WD-40, then digging it out. One of the holes is VERY deep. In fact, it seems to go through the axle housing. I poured oil into it and it didn't fill up, as if it was going into the axle housing. We've had several Farmalls with open or dirt-filled holes before, but none seemed to be that deep. Anyone ever dealt with these before? You can bet I'll be getting bolts into those holes real quick!
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|