Farmall & IHC Tractors Discussion Board |
Carb frustrations!!
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by J3nut on September 01, 2001 at 18:10:27 from (64.12.104.58):
I have a Super C with the Zenith carb. I put an IH brand rebuild kit in the carb and have the following results. Fully assembled the fuel will not shut off and overflows out the intake side. If I assemble the carb without the bowl gasket it works fine. I used a hint I found on this board and put a nipple in the bottom of the bowl with a piece of clear tubing hooked to it and am able to see that the fuel level is right where it should be. If I use a can of gas as the fuel bowl and set the throttle body on top, it works fine with or without a gasket. The gasket is not in the way of the float at any time and the float itself is in good condition and well within adjustment limits. Any ideas??? Thanks in advance.
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|