Farmall & IHC Tractors Discussion Board |
Super H brake Disks - What are the wear limits???
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bama Binder on July 23, 2001 at 10:41:54 from (206.5.110.200):
Couple of quick disk brake questions... The SH is getting some badly needed brake service. I have everything apart and aside from lots of rust and glazing of the brake pads and braking surfaces, everything looks ok...not great, but I think I can salvage everything but 1 disk where the pad seperated from the disk due to rust. The question is, how much pad is on NEW disks??? I have about 1/8-3/16" on the remaining pads, but what should new one ones have?? Also...the cast iron braking surfaces are pitted..not bad in some places, but not good in some others. I have cleaned them up with a sanding disk on a drill (poor man's milling machine), and the look OK. I'm going to hit the whole assembly with the sandblaster (except for the disks and balls) to clean everything and make sure I have the glaze off everything. Is there anything else I should do? Thanks for the help...BB
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|