Farmall & IHC Tractors Discussion Board |
frarmall a
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by tiny on May 14, 2001 at 17:51:40 from (206.67.167.250):
father in law has an "a" he had the mag cheked it needed points and condeser,cap,and mag cap. we put new plug wires on plugs looked good went to get a carb kit and found a whole carter carb [cheep,new take off] put that on went to start it up and started on about the third crank of the starter then went to full throttle. shut in down. tried again with father in law by carb it started and went to full throttle he played with the carb and got it to idle down. the problem is the linkage from governer to carb is not working. i looked at mine and when you move the throttle it moves the linkage all the way to the carb his dosn't. the govener was worked on a new bearring and nylon spacer or washer was put in. and put back on. any ideas . this board is full of good info. thanks tiny
Follow Ups:
Home
| Forums
Today's Featured Article -
The 8N and the Fox - by Zane Sherman. Dec. 13 1998, Renfroe, Alabama. Last niht I dreamed about the day that I plowed the field of about 10 acres over on what Jimmy and Dandy called the Ledbetter field. I was driving the 1948 8N Ford tractor that Jimmy bought in 48 new This was prebably in about 1951 and maybe even befor the house was built. This would have made me to be about16 years old and I drove the tractor for nothing and would have paid to drive it if I had had any money which I didn't, but neit
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|