Farmall & IHC Tractors Discussion Board |
Farmall M hydraulics
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Whitepark on May 11, 2001 at 20:16:26 from (205.198.23.242):
I want to use the lift all belly pump on my M to lift my chisel plow, which has one small cylinder. How do I hook it up and use it? the tractor has two capped fittings on the left and one on the right with the filler on the top, I poured a bit of oil in the filler tube and uncapped the fittings, pulled the lever to turn it on and a bunch of crud came out so I kept pouring oil in until it ran clean, then I hooked a line to one of the side fittings and a return slipped over the filler to test the pump since it has not been used in many years maby never, it worked fine but I need to know how to properly hook up my chisel plow hydraulic lines, it is a double acting cilinder, would this make any diference? there seems to be two positions on the on/off lever on the tractor, is this so? thanks for any help. Whitepark
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|