Farmall & IHC Tractors Discussion Board |
Need Help with Cub Clutch
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by David Wampler on May 05, 2001 at 11:17:28 from (66.43.229.117):
I just purchased a Cub. The clutch was making a noise and I thought it was shot since it would not totally disengage. I split the tractor and the clutch and pressure plate appear to be fine. However, the forks that hold the throwout bearing appear to be rubbing on the nuts that adjust the height of the throw out forks on the clutch. The noise only stops if the clutch pedal is half depressed. I would guess that the pedal is out of adjustment and causes the throw out bearing to travel to far twards the clutch. However, I am puzzeled as to why the clutch does not totally disengage. Any help on this issue would be greatly appreciated. THANKS
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|