| |
Return to List
Popeye the Ford 600 | About twenty years ago My brother bought a sad looking 600 Ford on the back line of a construction auction. It had a sweeper on it and appeared that it had not run in a while. We brought it home and cleaned the points and plugs and put gas in it. It would not crank with the starter so we pulled it off and it cranked. It smoked badly and had a great deal of back pressure. We pulled it apart and the cylinder walls and bearings looked good. We are thinking that all it needed was a set of rings and without any marks on the tops of the pistons we made the 'assumption' that it was standard bore. When the rings came in I took one out and put it in the bore to check the end gap. Huge gap apparently they had given us the wrong rings so we took them back and parts man said they were right for a standard bore 600. Went back and measured it and found that it was only a few thousandths from being 4 inches instead of 3 7/16 as it should. Went back to parts place and they had nothing listed for that size bore. The parts man looked it up by size and got us a set of rings for a GMC six cyl. I had to file the rings to the get the right end gap and put it together. It ran good and had lots of power. We had almost made the same mistake that the previous mechanic had and installed the wrong rings. It was a good little tractor and we used it at the hunting club and gardening for several years. It only had one headlight and it was affectionately named Popeye. Ron, SC, entered 2013-01-24 My Email Address: Not Displayed |
Return to List
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|