| |
Return to List
Never seen a 1066 do wheelies like that | Me and my dad have always used International equiptment. We had a 1066, 1566 and a 4386 and a 915 combine. Sence the 1066 was the smallest and I was the smallest in the family I drove the 1066. My brother dan drove ther 1566 and dad drove the 4386. And mom drove the 915 combine. My job was to disk we hade a 20-ft john deere dish but the tounge was bendable. once when I was pulling out of one of our more hiller chunks of land the tractor jerked I fell on the throttle and th disk weighting so much poped the front end of the tractor clean into the air! The only bad thing was the front axel broke and I got I a lot of troble I mean alot!!! Tim Houghlund, WI, entered 2007-11-18 My Email Address: Not Displayed |
Return to List
Home
| Forums
Today's Featured Article -
Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
John Deere B 1943
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|